The Vaporesso Armour S kit is a tough 100W single-battery mod in TPU armour that takes a 21700, or an 18650 with the sleeve. It has the Uni-Lock fire button, and it comes with the iTank 2 and GTi mesh coils.
Shipping: Calculated at checkout · Age verification required
Output
5–100W
Battery
1 × 21700 or 18650
Chip
AXON
Screen
0.96" TFT
Tank
iTank 2, 5ml
Coils
GTi mesh
The Vaporesso Armour S 100W Starter Kit is the single-battery version of the Armour. It's slimmer than the two-battery Armour Max, but it has the same tough TPU armour (a rubbery shell) over the whole body.
The Vaporesso Armour S runs on one 21700 battery, or an 18650 with the sleeve that ships inside the mod. A 21700 is just a bigger removable battery than the common 18650. The AXON chip takes it up to 100W, and the Uni-Lock fire button slides to lock, so it won't fire in your pocket. It comes with the iTank 2 and two GTi mesh coils, so all you need to add is a battery and some vape juice.
5–100W from one 21700 battery, or an 18650 with the sleeve that comes with it (the battery is sold separately)
Full-body TPU armour against drops and scratches, and a TPU cover over the tank glass
Uni-Lock fire button that slides to lock
Wattage, Pulse, F(t), ECO and temperature control (SS, Ni, Ti) modes
The battery door opens with one press, so swapping batteries is quick
Vaporesso Armour S 100W kit, Armour S starter kit, Vaporesso Armour S mod kit
Greg's Tip: Running a mod that takes removable 18650, 20700 or 21700 batteries? Always keep a charged spare on you (a full set if it takes two), so a dead battery doesn't leave you out of luck. Some mods let you vape while they charge, called pass-through. But plenty don't. For 18650s, the Samsung 25R is the workhorse of the vaping industry. And never carry a loose battery in a pocket or purse. Use a battery case. Our 18650 battery safety guide covers the rest.
Greg's Tip: Always keep a spare glass for your tank. If the glass breaks and you don't have one, you're out of luck. And if it does break, put the whole tank in a Ziploc bag right away so you don't lose any O-rings. Then check the O-rings for nicks before you put it back together. Need one? Check our replacement glass.
Vaporesso Armour S Coils (GTi Mesh)
The iTank 2 in the Armour S kit takes Vaporesso GTi mesh coils. These are sub-ohm coils, which means they're under 1 ohm and made for bigger clouds at higher watts. The 0.2Ω comes installed, and it's made for bigger clouds. The 0.4Ω runs a little bit cooler and gives you more flavor. All four GTi coils run fine under the Armour S's 100W limit.
GTi 0.15Ω MeshIn stock
0W50W100W
75–90WMost vapor, hardest on the battery
GTi 0.2Ω MeshIn stock
0W50W100W
60–75WInstalled in the kit
GTi 0.4Ω MeshIn stock
0W50W100W
50–60WIn the box, more flavor
GTi 0.5Ω MeshIn stock
0W50W100W
30–40WLongest battery life
We sell Vaporesso GTi coils by the pack, and we recommend always having a spare coil or two. If you only need one, please fill out our Single Coil form. We'll do our best. A spare iTank 2 holds 8ml with its bubble glass.
Armour S Battery Guide
The Armour S takes one 21700 battery, or an 18650 in the sleeve that ships inside the mod. We'd recommend a 21700, because it lasts a lot longer and handles 75W and up more easily. Use a high-drain battery (one made for high power) from a trusted brand. An 18650 like the Samsung 25R is fine with the 0.4Ω or 0.5Ω coil at moderate wattage. This mod takes a removable battery, so please make sure you read our 18650 battery safety guide before you put one in.
Never, ever carry a naked battery (one without a case) in your pocket or your purse. Keep it in a battery case, away from your keys and coins.
Armour S vs Armour Max
Armour S
Armour Max
Batteries
1 × 21700 or 18650
2 × 21700 or 18650
Power
5–100W
5–220W
Size
Slimmer and lighter
Bigger, longer battery life
Build
TPU armour, Uni-Lock
TPU armour, Uni-Lock
Coils
GTi mesh
GTi mesh
For two batteries and up to 220W, take a look at the Vaporesso Armour Max kit. If you don't want to deal with external batteries, the Armour Ultra has a 100W mod with the battery built in. You can also see all of our single-battery mods.
Custom Blend Tip: Start around 60W on the 0.2Ω coil, and work your way up from there. If you'd rather have flavor than big clouds, swap in the 0.4Ω. A lot of people like that one best.
Will It Work With My Device?
Any 510 tank up to about 30mm wide
Vaporesso GTi coils (0.15Ω, 0.2Ω, 0.4Ω, 0.5Ω)
21700 batteries, or 18650s with the sleeve
Vaporesso GTX or XROS pods
Coils that need more than 100W
Two-battery setups (it holds one cell)
Best Vape Juice for the Armour S
MAX VG freebase, 3–6mgGreatSmooth, thick vapor on GTi mesh at 50–75W
50/50 freebaseGoodDecent, but it can spit or flood in the 0.2Ω coil
Nicotine saltAvoidToo strong at sub-ohm power
For the Armour S, we'd recommend our freebase vape juice. Freebase is just the regular kind of nicotine, and we always like to suggest 3 to 6mg. MAX VG works best on GTi mesh, especially on the 0.2Ω coil, because 50/50 can spit in that one. On the 0.4Ω or 0.5Ω at lower wattage, 50/50 is usually fine. Every bottle of Custom Blend Vape Juice is made to order, and a 5 flavor sample pack lets you try a few flavors before you invest in a bigger bottle.
How to Use the Vaporesso Armour S
Press the battery door button. Put in a charged 21700 (or an 18650 in the sleeve) the way it's marked, and then close the door.
Click the fire button 5 times to turn it on.
Press the top cap on the iTank 2 to open the fill port. Fill it, close it, and then let the coil soak for at least 10 minutes. The longer, the better.
Set the wattage with the up and down buttons. Start around 60W on the 0.2Ω coil, and slowly turn it up from there.
Slide the Uni-Lock on the fire button to lock it before you put it in your pocket.
Vaporesso Armour S Reviews
Durability: The TPU shell and the covered tank glass hold up to drops that would crack a lot of other kits.
Size: It's easier to carry around than a dual-battery mod, and you still get 21700 battery life.
Flavor: A lot of people like the GTi 0.4Ω coil best for flavor, and the 0.2Ω makes the bigger clouds.
Keep in mind: It's still a little bit chunky for a single-battery mod, and it has no IP water rating.
Armour S Reviews From Experts
Published reviews from independent vape review sites, summarized in our own words. These aren't Custom Blend customer reviews and aren't counted in our star rating.
Rated 9 / 10
Si · Nov 2023
Expected to prefer the Armour Max but found the Armour S more ergonomic and practical out and about with the same vape quality, ranking it among his all-time favorite kits.
Liked: takes a 21700 or 18650; superb GTi coil flavor and lifespan; rugged, futuristic styling; excellent battery life for a single-cell mod
Watch for: no protective sleeve for the bubble glass
Questions & Answers
Does the Vaporesso Armour S come with a battery?
No. It takes one 21700, or an 18650 with the sleeve that comes with it, and batteries are sold separately.
What coils does the Vaporesso Armour S use?
It uses Vaporesso GTi mesh coils. The kit comes with a 0.2Ω and a 0.4Ω, and the 0.15Ω and 0.5Ω fit as well.
What tank comes with the Armour S kit?
It comes with the Vaporesso iTank 2. In this kit it holds 5ml, and there's a TPU protector over the glass.
Can I use an 18650 in the Armour S?
Yes, with the sleeve that ships inside the mod. A 21700 lasts longer, though, so that's what we'd recommend.
What's the difference between the Armour S and the Armour Max?
The Armour S takes one battery and goes up to 100W. The Armour Max takes two and goes up to 220W. Both of them have the TPU armour, the Uni-Lock and GTi coils.
Is the Vaporesso Armour S waterproof?
No. The TPU armour protects it from drops and bumps, but it doesn't have an IP water rating.
How do I lock the Armour S?
Slide the Uni-Lock on the fire button. That locks it, so it can't fire in your pocket.
What wattage should I use on the Armour S?
We recommend 60–75W with the 0.2Ω coil and 50–60W with the 0.4Ω. Start at the low end, and then turn it up until it tastes right to you.
For use by adults 21+.
Battery
1 × 21700, or 1 × 18650 with the included sleeve (not included)
Output
5–100W
Chip
AXON
Screen
0.96" TFT
Tank
iTank T, 6ml, slide-open top fill, top airflow
Coils
Vaporesso GTi mesh (0.2Ω and 0.4Ω included)
Durability
Full-body TPU protection
Charging
USB-C, 2A
In the box
Armour S mod, iTank T (6ml), 0.2Ω and 0.4Ω GTi mesh coils, spare glass, tank protector, 18650 sleeve, O-rings, refill plug, USB-C cable
We just relaunched our website, so our reviews got a fresh start too. Own one of these? We'd love for you to be one of the first to share your thoughts!