The Vaporesso Armour Octa kit is a 220W dual-18650 mod with eight layers of protection (IP68, IP69K, IP6X, 1.2m drops) and the 6ml iTank T dual mesh tank.
Shipping: Calculated at checkout · Age verification required
Output
Up to 220W
Batteries
2 × 18650
Chip
AXON 3.0
Protection
IP68 / IP69K / IP6X
Drop rating
1.2m
Tank
iTank T, 6ml
The Vaporesso Armour Octa 220W Starter Kit is one of the toughest dual-battery kits that Vaporesso makes, and it's named for its eight protection features. It runs on two 18650 batteries, which are the removable kind that most bigger mods use.
The Vaporesso Armour Octa is sealed to IP68, so it can sit underwater at 1m for 30 minutes. It's also rated IP69K against high-pressure, hot water jets and IP6X against dust, and it survives 1.2m drops from 26 angles. It also has safety electronics built in. It won't fire if your two batteries drift too far apart, and it stops charging if it gets too hot. It even cuts out if you accidentally hold the button down too long. The AXON 3.0 chip, which is the brain of the mod, puts up to 220W into the 6ml iTank T, and that tank takes GTi dual mesh coils.
Up to 220W from two 18650 batteries (sold separately), plus a Boost mode for steadier output
IP68 waterproof, IP69K water-jet proof, IP6X dust-tight and 1.2m drop resistant (mod only)
Voltage surge protection, so it won't fire when the two batteries are more than 0.9V apart
OVERTIME 2.0 cuts the power after an accidental 10-second press, and if it happens again, it shuts the mod off
Swipe-to-lock, a silicone grip, a TPU tank cover and a sealed USB-C port with 2.5A charging
The 6ml iTank T dual mesh tank, with 0.2Ω and 0.4Ω GTi dual mesh coils
Spare glass, spare tank protector, 2 O-rings, a silicone refill plug and a USB-C cable
User manual, warranty card and safety manual
Batteries aren't included, so you'll need two 18650s
Armour Octa Specs & Features
Spec
Vaporesso Armour Octa
Output
5–220W, with Boost mode
Batteries
2 × 18650, sold separately
Chip
AXON 3.0
Screen
0.96" TFT
Waterproof
IP68 (1m for 30+ minutes) and IP69K (100-bar, 85°C water jets)
Dust
IP6X dust-tight
Drops
1.2m, tested from 26 angles
Electronic safety
Voltage surge protection (cells over 0.9V apart), charging overheat cut-off at 75°C, OVERTIME 2.0 long-press protection
Lock
Swipe-to-lock
Charging
USB-C, 5V/2.5A, with a silicone port plug
Size
146.3 × 55 × 30.8mm, about 362g
Tank
iTank T dual mesh, 6ml, top fill, top airflow, TPU cover
Colors
Varies with stock (Vaporesso makes Dark Black, Titanium Grey, Vintage Green, Rally Blue, Rust Bronze and Aero White)
Greg's Tip: Running a mod that takes removable 18650, 20700 or 21700 batteries? Always keep a charged spare on you (a full set if it takes two), so a dead battery doesn't leave you out of luck. Some mods let you vape while they charge, called pass-through. But plenty don't. For 18650s, the Samsung 25R is the workhorse of the vaping industry. And never carry a loose battery in a pocket or purse. Use a battery case. Our 18650 battery safety guide covers the rest.
Greg's Tip: Always keep a spare glass for your tank. If the glass breaks and you don't have one, you're out of luck. And if it does break, put the whole tank in a Ziploc bag right away so you don't lose any O-rings. Then check the O-rings for nicks before you put it back together. Need one? Check our replacement glass.
The Eight Armour Features
Waterproof: IP68, sealed so it can go underwater.
Water-jet proof: IP69K, so it holds up to high-pressure, hot water jets.
Dust-proof: IP6X, dust-tight.
Shock-proof: rated for 1.2m drops, with an anti-collision pad and an armor-style cage.
Voltage surge protection: it won't fire when mixed, old or worn-out batteries are out of balance.
Charging overheat protection: it stops charging above 75°C.
OVERTIME 2.0: it stops accidental firing from a stuck button.
TPU protection: soft covers for the tank and the charging port.
The water, dust and drop ratings only apply to the mod, not the glass tank.
Armour Octa Batteries
The Armour Octa takes two 18650 batteries, and they're sold separately. We recommend a matched pair of high-drain batteries (made for high power) rated at least 20A, like the Samsung 25R. The mod has voltage surge protection, so it won't fire if the two batteries are more than 0.9V apart. That's why you always want to charge them and replace them as a pair. Since this mod uses removable batteries, you must read our 18650 battery safety guide first.
Never, ever carry a naked 18650 battery (one without a case) in your pocket or your purse, especially with keys or coins. Always keep your spare batteries in a battery case.
Armour Octa Coils
The iTank T in the Armour Octa kit takes Vaporesso GTi coils, and it comes with two GTi dual mesh coils. The 0.2Ω (best around 65W) comes installed, and the 0.4Ω (best around 55W) is in the box. The GTi 0.15Ω dual mesh fits too, and so do the regular GTi mesh coils (0.15Ω, 0.2Ω, 0.4Ω and 0.5Ω). These are all sub-ohm coils, which means they're under 1 ohm, and they're made for bigger clouds.
Mixed or mismatched batteries (the mod blocks firing)
Custom Blend Tip: The water and drop ratings cover the mod, not the glass tank. So if you ever drop your Armour Octa, take a good look at the iTank T glass before you vape on it again.
Best Vape Juice for the Armour Octa
MAX VG freebase, 3–6mgGreatThe right match for GTi dual mesh coils at 50–75W
50/50 freebaseGoodDecent, but it can spit or leak on the 0.2Ω coil
Nicotine saltAvoidFar too much nicotine at sub-ohm wattages, so save salts for a low-power pod
A kit like this needs freebase nicotine, which is just the regular kind of nicotine, and we always like to suggest 3 to 6mg. MAX VG is the best match for these GTi dual mesh coils. VG, or vegetable glycerin, is the thick part of the juice that makes the vapor, so MAX VG gives you big, dense clouds. At Custom Blend Vape Juice, any of our freebase vape juice flavors can be mixed in MAX VG, and we make each bottle by hand when your order comes in. If you're not sure which flavor to get, a vape juice sampler pack gets you five different flavors to try before you invest in a bigger bottle. If you also use a low-power MTL pod (mouth-to-lung, a tighter draw like a cigarette), our nicotine salts are the smoother kind of nicotine made for that.
How to Use the Armour Octa
Open the battery cover and put in two matched, fully charged 18650s. Make sure the positive ends line up with the markings.
Click the fire button 5 times fast to turn it on, and do the same thing to turn it off.
Slide the iTank T top open, and fill it slowly down the side of the glass. The silicone plug seals the fill hole. If it's a new coil, let it soak for at least 10 minutes, and the longer, the better.
Set the wattage with the adjustment buttons. Start at the low end of the coil's range, take a few drags, and then work your way up.
Swipe to lock it before it goes in your pocket.
Armour Octa Not Firing? Try This
Battery warning: the batteries are out of balance. Charge both of them fully, or replace them with a matched pair.
Cut out mid-drag: OVERTIME 2.0 stops any press that lasts longer than 10 seconds. Just let go of the button and fire it again.
Won't charge: let it cool down a little bit, since charging stops above 75°C.
Locked: swipe the lock switch to unlock it.
No coil: reseat the GTi coil, and make sure the tank is screwed all the way down.
Vaporesso Armour Octa Reviews
Durability: it's one of the toughest mods out there, and the water-jet, dust and drop ratings show it.
Safety: the battery-balance and long-press protections are very handy if you're new to dual-battery mods.
Tank: the iTank T is easy to fill, and it resists leaks.
Look out for: it's heavy, at about 362g before batteries. And because of the strict battery check, old or mismatched batteries won't fire.
Armour Octa Reviews From Experts
Published reviews from independent vape review sites, summarized in our own words. These aren't Custom Blend customer reviews and aren't counted in our star rating.
Rated 4.5 / 5
Jeremy · Oct 2026
Called it a big win and one of his favorite box mods of the year: slick, tough and comfortable, with a reliable, feature-rich AXON 3.0 chip and an iTank T whose dual-mesh GTi coils taste excellent; only the narrow 510 platform held it back.
Liked: very durable yet stylish; secure battery door and manual lock switch; comfortable leather padding; iTank T delivers great flavor
Watch for: narrow 510 platform (about 23.6mm); visible chassis seams; some screen text is tiny
Rated 5 / 5
Alistair · Sep 2026
Called it an excellent kit for powerful direct-lung vaping, easy to use and very rugged with long sessions from two 18650s, plus an iTank T that delivers precise flavor and dense clouds.
Liked: excellent fit and finish; durable, shock-absorbing body; simple menus with a side lock switch; 6ml tank with excellent flavor
Watch for: the reviewer reported no drawbacks
Questions & Answers
Does the Vaporesso Armour Octa come with batteries?
No. It takes two 18650 batteries, and they're sold separately. We'd recommend a matched pair, like Samsung 25Rs.
What coils does the Armour Octa use?
It uses Vaporesso GTi coils in the iTank T. The kit comes with GTi 0.2Ω and 0.4Ω dual mesh coils, and the GTi 0.15Ω dual mesh and the regular GTi mesh coils fit too.
Is the Vaporesso Armour Octa waterproof?
Yes. The mod is rated IP68 (1m for 30 minutes), IP69K against water jets and IP6X dust-tight. Those ratings only cover the mod, not the tank.
Why won't my Armour Octa fire with my batteries?
Its voltage surge protection won't let it fire if the two batteries are more than 0.9V apart. Charge both of them fully, or use a fresh matched pair.
What are the eight Armour features?
Waterproof, water-jet proof, dust-proof, shock-proof, voltage surge protection, charging overheat protection, OVERTIME 2.0 and TPU protection.
What tank comes with the Armour Octa kit?
It comes with the 6ml iTank T dual mesh version, which has top fill and top airflow.
How heavy is the Armour Octa?
It's about 362g without batteries, and it measures 146.3 × 55 × 30.8mm.
How do I lock the Armour Octa?
Use the swipe-to-lock switch. That locks the buttons, so it won't fire in your pocket.
Armour Octa vs Armour Ultra: what's the difference?
Both are tough Vaporesso kits, and both come with the 6ml iTank T. The Octa runs on two 18650s and goes up to 220W, and it has the eight protection features. The Armour Ultra is a 100W kit with a built-in 5500mAh battery, so there are no batteries to buy. The Armour Max is another 220W kit, and it takes two 21700 or 18650 batteries.
For use by adults 21+.
Battery
2 × 18650 (not included); Battery Guard stops firing if the two cells drift more than 0.9V apart
Output
5–220W
Screen
0.96" TFT
Durability
IP68, IP69K and IP6X; 1.2m drop resistance
Tank
iTank T, 6ml, sliding top fill, top airflow
Coils
Vaporesso GTi dual mesh (0.2Ω and 0.4Ω included)
Charging
USB-C, 2.5A
In the box
Armour Octa mod, iTank T (6ml), 0.2Ω and 0.4Ω GTi dual mesh coils, spare glass, spare tank protector, O-rings, refill plug, USB-C cable
We just relaunched our website, so our reviews got a fresh start too. Own one of these? We'd love for you to be one of the first to share your thoughts!