WARNING: This product contains nicotine. Nicotine is an addictive chemical.
All our vape juice is fully customizable · Try 5 flavors in a sample pack → About UsSign in
GeekVape Sonder Q Pod Kit 1000mAh

GeekVape

GeekVape Sonder Q Pod Kit 1000mAh

$24.95

The GeekVape Sonder Q is a draw-activated 20W pod kit with a 1000mAh battery and an airflow switch. It takes refillable 2ml GeekVape Q pods that have the coil built in.

  • Up to 20W from a 1000mAh battery
  • Draw-activated, so there are no buttons to learn
  • Takes GeekVape Q pods, 0.6Ω to 1.2Ω

Limit 3 per order. Need more? Request a larger quantity.

  • SKU: MOD-GEEKVAPE-SONDER-Q-KIT
  • Availability: In stock
  • Shipping: Calculated at checkout · Age verification required
Capacity
2ml Q cartridge
Output
Up to 20W
Battery
Built-in 1000mAh
Firing
Draw-activated
Pods
GeekVape Q (0.8Ω included)
Charging
USB-C

The GeekVape Sonder Q Pod Kit is about as easy as GeekVape gets, and it's one of the pod systems we like in our beginner's guide. It weighs only 39g, and there are no buttons on it. It has a 1000mAh battery and sets its own power, up to 20W. You fill it from the top, and it fires when you inhale. There's also an airflow switch on the side.

The Sonder Q uses refillable 2ml GeekVape Q pods with the coil built in, and those are the same pods as the Wenax Q family. It's made for mouth-to-lung (MTL), which is a tighter draw a lot like a cigarette. If you open the airflow up, you get a looser draw called restricted lung, which is in between MTL and direct lung. Nic salt, the smoother kind of nicotine made for pod kits, is what we normally recommend. Low-strength freebase, which is just regular nicotine, works too.

  • Built-in 1000mAh battery, and GeekVape rates it at up to two days of typical use
  • It's draw-activated, so there are no buttons or settings to learn
  • An airflow switch on the side goes from a tight MTL draw to a looser restricted lung draw
  • The 2ml Q pod fills from the top. Just lift off the mouthpiece cap
  • Takes GeekVape Q pods. The 0.8Ω comes in the box, and the 0.6Ω and 1.2Ω work too
  • A three-color light shows how much battery you have left

What's in the Box

  • 1 × GeekVape Sonder Q device (1000mAh built in)
  • 1 × GeekVape Q cartridge, 2ml, 0.8Ω coil built in
  • User manual

There's no USB-C cable in the standard box, but any USB-C cable and phone charger will work.

GeekVape Sonder Q Specs & Features

SpecGeekVape Sonder Q
BatteryBuilt-in 1000mAh
Output5–20W, set automatically by the pod
PodGeekVape Q cartridge, 2ml, top fill, coil built in
Included pod0.8Ω (12–18W)
FiringDraw-activated (auto draw)
AirflowAdjustable airflow switch on the side
IndicatorGreen / blue / red battery light
Weight39.1g
SizeAbout 108.9 × 23.8 × 13.8mm
ChargingUSB-C
Also listed asGeekVape Sonder Q pod system, Geek Vape Sonder Q kit, Sonder Q vape

Sonder Q Pods & Resistances

The Sonder Q pods are standard GeekVape Q cartridges, and the coil is built into each one. You can keep refilling a pod, and most people get one to two weeks out of it. You'll know when to change it, as it'll start putting out less vapor, and the flavor will be a little muted. The 0.8Ω pod is a good middle ground. The 1.2Ω gives you the tightest draw, and it's the most like a cigarette.

Q 1.2ΩIn stock
8–12WTight MTL, nic salts
Q 0.8ΩIn stock
12–18WMTL (included)
Q 0.6ΩIn stock
18–20WLooser draw (device tops out at 20W)

We sell spare GeekVape Q replacement pods by the pack, in 1.2Ω, 0.8Ω and 0.6Ω. We don't recommend the 0.4Ω Q pod for this one, though. It needs a Q device with more power, like the Wenax Q Ultra.

Will It Work With My Device?

  • GeekVape Q pods: 1.2Ω, 0.8Ω and 0.6Ω
  • The same Q pods as the Wenax Q, Wenax Q Mini, Aegis Q and Digi Q
  • Any USB-C cable and phone charger
  • The 0.4Ω Q pod (not supported on the Sonder Q)
  • GeekVape U pods (those fit the Sonder U and AU)
  • B series coils or Aegis pods

Sonder Q vs Sonder U

Sonder QSonder U
Battery1000mAh1000mAh
OutputUp to 20WUp to 20W
PodGeekVape Q, 2ml, top fillGeekVape U, 2ml, side fill
AirflowAdjustable switchFixed
FiringDraw-activatedDraw-activated

They have the same battery and the same power. The Sonder Q adds airflow that you can adjust, and it uses Q pods instead of U pods. Take a look at the GeekVape Sonder U, or see all of our pod systems. If you'd like a little bit more power, GeekVape's newer Sonder Q2 and Q3 have bigger batteries and go up to 30W. They still take Q pods.

Custom Blend Tip: Keep your drags gentle and a little bit on the short side. If the Sonder Q blinks red twice, that means you held a drag for over 10 seconds, and it cut off for safety.

Best Vape Juice for the Sonder Q

It all depends on which pod you're using.

Q 0.8Ω / 1.2Ω: nicotine salt, 24–40mgGreat A smooth MTL draw, and the best match
Q 0.6Ω: nicotine salt, 20mgGood A looser, warmer draw
50/50 freebase, 6–12mg (6–18mg in the 1.2Ω)Great Wicks well in a 2ml pod
Thick MAX VG (vegetable glycerin, for vapor) freebaseAvoid Wicks too slowly for a small MTL coil

Our nicotine salts are what we normally recommend for the Sonder Q, in any of the Q pods. For pod systems, most people start around 24 to 40mg of salt nicotine. If you're coming off of a disposable vape, those are usually 50mg, so that's where we'd recommend you start. Our freebase vape juice, which is just regular nicotine, works well in the Q pods too, and when in doubt, 50/50 is usually a great option. We mix every bottle by hand after you order it, in the exact nicotine strength that you pick. Not sure on a flavor yet? A vape juice sample pack lets you try five of them before you invest in a bigger bottle.

How to Fill the Sonder Q

  1. Charge the Sonder Q over USB-C until the light turns green.
  2. Pull the Q pod out of the device.
  3. Lift off the mouthpiece cap, and fill the pod from the top to just below the max line. Never overfill it.
  4. Put the cap back on, and let a new pod sit for at least 10 minutes so the cotton can soak up the juice. The longer, the better.
  5. Press the pod back in, set the airflow switch and take a few gentle drags.

Sonder Q Light Guide & Blinking Red

  • Green: battery above 70%. Blue: 30–70%. Red: below 30%.
  • Sonder Q blinking red 5 times: the battery is empty, so charge it.
  • Blinking red 2 times: you held a drag for over 10 seconds, and it cut off for safety. Try taking shorter drags.
  • Blinking red 8 times: that means there's a short circuit. Reseat the pod, or try a new one.
  • Burnt taste: the pod ran low, or it's worn out. Refill it a little sooner, or replace the pod.

GeekVape Sonder Q Reviews

  • Ease: it's very simple to use. You just fill it and inhale.
  • Battery: the 1000mAh lasts most MTL vapers a long day or more.
  • Pods: Q pods are easy to find, and they fit a bunch of GeekVape devices.
  • Watch out for: there's no cable in the box, and at 20W max, it's not made for big clouds.

Sonder Q Reviews From Experts

Published reviews from independent vape review sites, summarized in our own words. These aren't Custom Blend customer reviews and aren't counted in our star rating.

Rated 9.962 / 10

Si · Aug 2023

Placed it among the top three entry-level pods and the best MTL pod Geekvape had made, a big step up from the original that doesn't look or feel budget.

Liked: flavor among the very best; long-lasting, inexpensive pods; no leaking; adjustable airflow

Watch for: reviewer found nothing to fault

Rated 8 / 10

Michelle · May 2023

Top-notch performance for about the price of two disposables, marked down for a leaky pod on one of three units and weak instructions.

Liked: amazing flavor and vapor; wide airflow range from tight MTL to RDL; easy top fill; flavor still strong after 25 refills

Watch for: one pod leaked into the device; only one pod supplied; slow charging (about 1h15)

Rated 3.5 / 5

Anthony · Jun 2023

Reviewed with the Wenax Q; the Sonder Q is the cheaper, smaller and simpler of the two, a good performer that is easy to use and takes long-lasting, flavorful pods.

Liked: solid build with a firmly held pod; clear pod shows e-liquid level; practical airflow slider; all-day battery life

Watch for: only one pod included; slower charging

Questions & Answers

What pods does the GeekVape Sonder Q use?

It uses GeekVape Q cartridges with the coil built in. The kit comes with a 0.8Ω, and we sell Q replacement pods by the pack.

Does the Sonder Q work with the 0.4Ω Q pod?

No. Use the 0.6Ω, 0.8Ω or 1.2Ω Q pods. The 0.4Ω needs a device with more power, like the Wenax Q Ultra.

How do I fill the Sonder Q?

Pull the pod out, lift off the mouthpiece cap and fill it from the top. On a new pod, let it soak for at least 10 minutes before you vape on it.

Does the Sonder Q have a button?

No. It's draw-activated, so it fires when you inhale.

How long does the Sonder Q battery last?

GeekVape rates the 1000mAh battery at up to two days of typical use, but that depends on how much you vape. It charges over USB-C.

Does the Sonder Q come with a charger?

The standard box has the device and one pod, but no cable. Any USB-C cable and phone charger will work. Just never charge your vape unattended.

Why is my Sonder Q blinking red?

Five blinks means the battery is low, so charge it. Two blinks means you held a drag for over 10 seconds. Eight blinks means there's a short, so reseat or replace the pod.

What's the difference between the Sonder Q and Sonder U?

They have the same 1000mAh battery and the same 20W. The Sonder Q has adjustable airflow, and it takes Q pods. The Sonder U uses U pods.

Can I use freebase e-liquid in the Sonder Q?

Yes. Freebase in a 50/50 works well in the Q pods, and we suggest 6 to 12mg in the 0.6Ω and 0.8Ω pods. But most people use nic salt in a pod kit like this, and it's the best match for the 0.8Ω and 1.2Ω pods. Adults 21+ only.

For use by adults 21+.

Customer Reviews

We just relaunched our website, so our reviews got a fresh start too. Own one of these? We'd love for you to be one of the first to share your thoughts!

Contact Us