WARNING: This product contains nicotine. Nicotine is an addictive chemical.
All our vape juice is fully customizable · Try 5 flavors in a sample pack → About UsSign in
SMOK Morph 3 230W Kit with T-Air Tank

SMOK

SMOK Morph 3 230W Kit with T-Air Tank

$49.95

The SMOK Morph 3 kit is a 230W dual-18650 vape mod with a 0.96" color screen, and it comes with the leak-resistant 5ml T-Air tank and TA mesh coils.

  • Up to 230W from two 18650s
  • Top-airflow T-Air tank, fewer leaks
  • TA mesh coils twist in, no tools

Limit 3 per order. Need more? Request a larger quantity.

  • SKU: MOD-SMOK-MORPH-3-KIT
  • Availability: In stock
  • Shipping: Calculated at checkout · Age verification required
Output
5–230W
Batteries
2 × 18650
Modes
VW + TC
Screen
0.96" color
Tank
T-Air, 5ml
Airflow
Top, leak-resistant

The SMOK Morph 3 230W Kit is the third SMOK Morph, and it's a box mod, the bigger kind of vape where you set the wattage. It runs on two 18650 batteries (the removable, rechargeable kind), it goes all the way up to 230W, and it comes with SMOK's T-Air tank. The SMOK Morph 3 adjusts its output as the batteries run down, so the power stays steady. It charges over 2A USB-C, and everything shows up on a 0.96-inch color screen.

Leaking is a fairly common issue with tanks. The 5ml T-Air tank pulls its air in from the top, away from the coil's juice holes, so this Morph 3 vape is a lot less likely to leak than a tank with bottom airflow.

  • 5–230W in wattage mode (10–230W in temperature control, or TC) from two 18650 batteries, which are sold separately
  • Variable wattage and temperature control for nickel (Ni), titanium (Ti) and stainless steel (SS) wire, and it reads your coil on its own
  • Adaptive output that keeps the power steady as the batteries run down
  • 0.96" color TFT screen and 2A USB-C charging
  • 5ml T-Air tank with a quarter-turn top cap, two fill ports and adjustable honeycomb top airflow
  • TA mesh coils (0.2Ω and 0.4Ω included) that twist in and out without any tools

What's in the Box

  • 1 × SMOK Morph 3 mod
  • 1 × T-Air tank (5ml)
  • 1 × TA 0.2Ω meshed coil and 1 × TA 0.4Ω meshed coil
  • 1 × spare glass, a USB-C cable and the user manual
  • Batteries aren't included, so you'll need two 18650s

SMOK Morph 3 Specs & Features

SpecSMOK Morph 3 230W Kit
Output5–230W (VW), 10–230W (TC), 1.0–8.2V
Batteries2 × 18650, sold separately
ModesVariable wattage and temperature control (Ni, Ti, SS), 200–600°F
Resistance range0.1–2.5Ω (VW), 0.05–2.0Ω (TC)
Screen0.96" color TFT
Mod sizeAbout 88 × 46 × 33.8mm, 124g without batteries
Tank fitAccepts tanks up to about 33mm
ChargingUSB-C, 2A
TankT-Air, 5ml, quarter-turn top fill with dual ports, adjustable honeycomb top airflow
CoilsSMOK TA series meshed coils
ColorsVaries with stock
Also listed asSMOK Morph 3 Mod Kit, SMOK Morph 3 Starter Kit, Morph 3 Kit

Greg's Tip: Running a mod that takes removable 18650, 20700 or 21700 batteries? Always keep a charged spare on you (a full set if it takes two), so a dead battery doesn't leave you out of luck. Some mods let you vape while they charge, called pass-through. But plenty don't. For 18650s, the Samsung 25R is the workhorse of the vaping industry. And never carry a loose battery in a pocket or purse. Use a battery case. Our 18650 battery safety guide covers the rest.

Greg's Tip: Always keep a spare glass for your tank. If the glass breaks and you don't have one, you're out of luck. And if it does break, put the whole tank in a Ziploc bag right away so you don't lose any O-rings. Then check the O-rings for nicks before you put it back together. Need one? Check our replacement glass.

Greg's Tip: SMOK makes a ton of different coils, and most of their tanks take their own. It's confusing, so folks buy the wrong ones all the time. Before you order, check the name printed on your old coil or the box it came in. Our replacement coils page lists exactly what fits what.

SMOK Morph 3 Coils (TA Coils)

Morph 3 coils are SMOK's TA series mesh coils, and they're made for the T-Air tank. The 0.2Ω is a great all-around coil. It's made for direct-lung vaping, where the vapor goes straight to your lungs, and it puts out plenty of vapor. The 0.4Ω runs at lower power, so you get a little bit more flavor and longer battery life. SMOK also makes a 0.15Ω TA dual-mesh coil for bigger clouds. Older TFV and RPM coils won't fit this tank.

TA 0.4Ω MeshedNot stocked
20–45WMore flavor, easier on battery and juice
TA 0.2Ω MeshedNot stocked
50–70WGreat all-around coil (best around 65W)

We don't carry SMOK TA coils yet. If you'd like us to, please request Morph 3 coils, and we'll do our best.

SMOK Morph 2 vs Morph 3

SMOK Morph 3SMOK Morph 2
Batteries2 × 186502 × 18650
Max output230W230W
TankT-Air, top airflow, TA coilsTFV18, bottom airflow, TFV18 coils
Best forHigh-power clouds with fewer leaksOwners who already stock TFV18 coils

If you already have a Morph 2, the tank in that kit takes TFV18 coils, and we have those in stock.

SMOK Morph 3 Battery Guide

The Morph 3 needs two 18650 batteries, and they're sold separately. We recommend a matched pair, which just means the same brand and model. You want high-drain batteries (made for high power) rated at least 20A, and the Samsung 25R is a good one. Always charge them together and replace them together. The 2A USB-C port is handy, but an external battery charger is gentler on them. Since the Morph 3 uses removable batteries, you must read our 18650 battery safety guide first.

Never, ever carry a naked battery (one without a case) in your pocket or purse. Keys or coins touching it can make it short, so please keep it in a battery case.

Will It Work With My Tank?

  • The included T-Air tank
  • Any 510 sub-ohm tank up to about 33mm, like the SMOK TFV18 or GeekVape Zeus
  • Rebuildable tanks, using TC with Ni, Ti or SS wire
  • Pods and pod cartridges (it's a 510 mod, with the standard screw-on thread)
  • Tanks over 33mm wide

Custom Blend Tip: The battery door is a snug fit with both batteries in, so make sure they're fully seated, and then press the door firmly until it closes. If the vapor ever seems weak, check that you're in VW (variable wattage) mode and not TC.

Best Vape Juice for the Morph 3

TA mesh coils are sub-ohm coils (under 1 ohm, made for bigger clouds), and at 20–70W, the Morph 3 is a direct-lung kit. For sub-ohm coils, we always like to suggest freebase, which is the regular kind of nicotine, at 3 to 6mg. VG, or vegetable glycerin, is the thick part of the juice that makes the vapor, so MAX VG makes the most vapor. On a kit like this, MAX VG works best, and 50/50 is usually fine at the lower end of the wattage, like on the 0.4Ω.

MAX VG freebase, 3–6mgGreat Smooth, dense vapor on both TA coils
50/50 freebase, 3–6mgGood Fine on the 0.4Ω at lower power
Nicotine saltAvoid Way too strong for sub-ohm vaping. Save nic salt for a pod system

Every one of our freebase vape juice flavors comes in 50/50 and MAX VG, and we mix each bottle by hand after your order comes in, at the exact nicotine strength that you pick. Not sure on a flavor yet? Try five of them in our vape juice sample pack before you invest in a bigger bottle.

SMOK Morph 3 Manual: Quick Start

  1. Pull back the battery door and put in two charged 18650s, with the positive ends facing the way they're marked. Then press the door firmly until it closes.
  2. Press the fire button 5 times quickly to turn it on or off.
  3. Screw on the tank, and the mod reads the coil resistance on its own.
  4. Use the up and down buttons to set the wattage. Start around 50W on the 0.2Ω coil, or 30W on the 0.4Ω. Take a few drags, and then slowly work your way up to where you like it.
  5. To fill the T-Air, give the top cap a quarter turn, fill through either port and turn it closed. On a new coil, wait at least 10 minutes before you vape. The longer, the better.
  6. The SMOK manual has the button combinations to switch between VW and TC modes, and it also shows you how to lock the buttons.

SMOK Morph 3 Reviews

  • Build: it feels solid and comfortable in your hand, and it fires quickly.
  • Battery life: with two batteries in it, it lasts a long time.
  • Tank: a lot of people pick this kit for the top-airflow T-Air tank. It barely leaks, and it makes decent vapor.
  • Keep in mind: it's on the heavy side, and the screen can be hard to read in bright sun. The battery door also takes a firm push with the batteries in.

Morph 3 Troubleshooting

  • Battery door won't close: make sure both batteries are fully seated, and then press firmly. It's a snug fit.
  • Reads no coil: screw the coil all the way into the tank and the tank snugly onto the 510 connection. Then clean the center pin.
  • Burnt taste on a new coil: it probably wasn't primed long enough. Next time, drip a few drops of juice on the exposed white cotton, wait at least 10 minutes and start at a lower wattage.
  • Weak vapor: make sure you're in VW mode and not TC, unless you're running a TC wire.

Morph 3 Reviews From Experts

Published reviews from independent vape review sites, summarized in our own words. These aren't Custom Blend customer reviews and aren't counted in our star rating.

Rated 9.4 / 10

Kevin · Aug 2023

Said that, unusually for SMOK, the Morph 3 is a sleek, well-designed mod that looks and feels like quality, performed well in all his tests and suits intermediate or experienced vapers who like a hefty device.

Liked: very good build quality and design; fast firing; comfortable leather-padded grip; long battery life from two 18650s

Watch for: heavy for some; battery door needs a firm press with batteries in

Questions & Answers

Does the SMOK Morph 3 come with batteries?

No. You'll need two 18650 batteries, and they're sold separately. We recommend a matched pair of Samsung 25Rs.

What coils does the SMOK Morph 3 use?

The T-Air tank takes SMOK TA mesh coils. The kit comes with a 0.2Ω (50–70W) and a 0.4Ω (about 20–45W).

Do TFV or RPM coils fit the Morph 3 tank?

No. The T-Air tank only takes SMOK TA series coils.

What's the difference between the SMOK Morph 2 and Morph 3?

Both run on two 18650s at up to 230W, and the big difference is the tank. The Morph 2 kit came with the TFV18, which has bottom airflow. The Morph 3 comes with the T-Air, which has top airflow and takes TA coils.

Is the Morph 3 vape leak-resistant?

Yes, more than most tanks. The T-Air takes its air in at the top, so there are no airflow holes at the bottom for juice to leak out of.

How much does the T-Air tank hold?

It holds 5ml.

Where can I find the SMOK Morph 3 manual?

It comes in the box. If you lost yours, please contact us, and we'll help you with the button combinations.

What wattage should I use on the SMOK Morph 3?

We recommend running the 0.2Ω TA coil at 50–70W and the 0.4Ω at about 20–45W. On a new coil, start at the low end and work your way up, and the coil will last longer if you do that.

Can I charge the Morph 3 with USB-C?

Yes, at up to 2A, but an external charger is easier on the batteries. And never charge your vape unattended. You always want to be awake and nearby.

For use by adults 21+.

Customer Reviews

We just relaunched our website, so our reviews got a fresh start too. Own one of these? We'd love for you to be one of the first to share your thoughts!

Contact Us