
Uwell
Uwell Crown 4 Replacement Coils
$13.95
Uwell Crown 4 coils in 0.23Ω UN2 mesh and 0.2Ω SS904L. They fit the Crown 4 (Crown IV) tank.
- 0.23Ω UN2 mesh or 0.2Ω SS904L
- Fits the Uwell Crown 4 tank
- Rated 60–80W
Limit 5 per order. Need more? Request a larger quantity.
- Resistances
- 0.2Ω, 0.23Ω
- Wattage
- 60–80W
- Draw style
- Direct lung
- Sold as
- By the pack
Uwell Crown 4 Replacement Coils fit the Crown 4 tank, which some folks call the Crown IV. We carry two.
The 0.23Ω UN2 is a mesh coil rated by Uwell for 60 to 70 watts. The 0.2Ω is made from SS904L stainless steel, and it runs at 70 to 80 watts. Both give you a wide-open draw straight to the lungs (DTL, or direct-to-lung).
- 0.23Ω UN2 mesh at 60–70W
- 0.2Ω SS904L stainless steel at 70–80W
- Made for the Crown 4 tank
- Sold by the pack
Resistance & Wattage
Will Crown 4 Coils Fit My Tank?
- Uwell Crown 4 (Crown IV) tank
- Uwell Crown 4 kit (the tank it comes with)
- Uwell Crown 5, which takes Crown 5 coils
- Uwell Valyrian tanks
Best Vape Juice for Crown 4 Coils
Go with freebase (regular nicotine) here, usually between 3 and 6mg. MAX VG is what we'd reach for first, since it's thick enough for big vapor. If you run the coil at low watts, 50/50 is usually fine.
Every bottle of our freebase vape juice is mixed by hand when you order it, and you pick the PG (propylene glycol, carries flavor) / VG ratio. Not sure on a flavor? Our 5 flavor sample pack lets you try five before you invest in a bigger bottle.
Custom Blend Tip: Not sure which to pick? The 0.23Ω UN2 mesh runs at a little lower power, so it's easier on your batteries and your juice.
How to Change the Coil
- Work over a table or a flat counter, since a dropped O-ring is a pain to find. Empty the tank and take the base off.
- Take the used coil out, and look over the O-rings. A nicked one can leak.
- Wet the cotton on the new coil. A few drops in each wicking hole and a few down the middle will do.
- Install it, put the tank back together and fill it up.
- Now wait at least 10 minutes. The longer, the better.
- Set your watts low to start, take a few drags and go up from there.
How to Tell a Coil Is Done
- It starts putting out less vapor
- The flavor gets a little muted, or it tastes burnt after you've refilled
- Juice starts to pop or spit when you take a drag
- It all depends on how much you use them. Really sweet juice wears a coil out sooner
Questions & Answers
What's the difference between the two Crown 4 coils?
The 0.23Ω is UN2 mesh at 60 to 70 watts. The 0.2Ω is SS904L stainless steel at 70 to 80 watts.
Is Crown IV the same as Crown 4?
Yes, it's the same tank.
Do these fit a Crown 5?
No, the Crown 5 has its own coils.
For use by adults 21+.
| Compatible with | the Uwell Crown 4 (Crown IV) tank, including the one in the Crown 4 kit |
|---|---|
| Resistances | 0.2Ω SS904L (70–80W), 0.23Ω UN2 Meshed (60–70W) |
| Sold as | By the pack |
See our Shipping Policy and Returns.
You May Also Like
Customer Reviews
We just relaunched our website, so our reviews got a fresh start too. Own one of these? We'd love for you to be one of the first to share your thoughts!




